Best practice for the Message Selector syntax in JMS connector Get Operation

Document created by Pavan_Sirasanambedu Employee on Jan 29, 2015Last modified by dave_lesshafft on Mar 1, 2016
Version 2Show Document
  • View in full screen mode
This article helps you to give proper syntax for Message Selector in JMS connector Get operation.
Please go through below links to know about Message selector syntax.


Please give proper syntax for message selector then you will get message based on message selector syntax otherwise it will throw an error.


For example, if you want to pick the messages based on message id, here is the syntax,
JMSMessageID = 'ID:WN7-2F5TD02-53113-1422433697123-7:1:1:1:1'


Here is the screen shot for JMS Connector Get Operation,


Based on your requirement provide correct syntax for Message Selector.
3 people found this helpful