Boomi Buzz: Blogs & Events
Boomi Training & Certification
About the Community
to create and rate content, and to follow, bookmark, and share content with other members.
Is there any other way to dynamically set the value of the URL parameter for the standard HTTP Client Connector that does not require building a branded connector?
Question asked by
on Nov 20, 2012
on Nov 29, 2012 by russellembling791
How do I set the following information dynamically?
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 2 comments
(Required, will not be published)
Nov 20, 2012 3:10 PM
You can use Replacement Variables in the Operation to configure dynamic aspects of the URL but the base URL (e.g. http://www.myapp.com/) configured in the Connection componnet cannot be set dynamically at runtime.
1 person found this helpful
Nov 29, 2012 11:06 AM
Another workaround might be to change the Connector URL at runtime by making it an Extension Property (note: these are environment-wide so be careful because you'll be changing for all other processes that use it).
Make it an extension via the "extensions" button when building the process:
Change the extension on the fly within the environment (this is done when running as a test or in the Atom Management section under each environment):
Retrieving data ...
Why I get connection refused when trying to connect to a Web Service via a local Atom and it is working for Test Atom Cloud?
Account executions exceeded limit of 20/50
Message queuing issues on Cloud atoms
Remove leading zeros
CSV File to Pivot Table?