Say It Takes Process Property 1 Value as x at 5 am
It Takes Proscess Property 1 Value as y at 6 am
The only way I can think of doing this is getting the current time during process executing and doing some logic to set a process property based on the time.
Date Mask — Choose or specify the format for the date value.
Current Date — The current system date/time.
Relative Date — The current system date/time offset by the specified calculation. You can set it plus or minus (+/-) n seconds, minutes, hours, days, weeks, months or years.
Last Run Date — The date/time when the given process was last executed. This value is updated every time the process executes, whether successfully or not. The value is represented in the local time of the machine where the atom is installed (as opposed to GMT/UTC time). If the process has not been run before, this value defaults to 12/31/1969 19:00:00.
Last Successful Run Date — The date/time when the given process was last executed successfully. This value is only updated when the process finishes execution without an error. The value is represented in the local time of the machine where the atom is installed (as opposed to GMT/UTC time).
Use Decision Box to compare current rime value time.
In Decision Box parameter value should be like below.
Have More than 2 Paths
You can chain your Decision shapes like so:
You can use Route shape to send documents in more than 2 paths
Retrieving data ...